Common uses for aluminum sheets are:
1-8 series aluminum alloy plates are often used in lighting; solar reflectors; building decoration; interior decoration: ceilings, walls, dll.; furniture, cabinets; elevators; signs, nameplates, bags; interior and exterior decoration of cars; interior decorations: such as photo frames , aluminum plate painting, relief, dll.; peralatan Rumah Tangga: refrigerators, microwave ovens, audio equipment, dll.; aerospace and military aspects, such as China’s large aircraft manufacturing, Shenzhou spacecraft series, satellites, dll.; mechanical parts processing; mold manufacturing; chemical industry, insulation pipes cladding;
Aluminum plates are usually divided into the following two types:
1. Divided by thickness: (unit: mm)
Thin plate (lembaran aluminium) 0.15-2.0
Regular plate (lembaran aluminium) 2.0-6.0
Medium plate (plat aluminium) 6.0-25.0
Thick plate (plat aluminium) 25-200 super thick plate above 200
2. According to the alloy composition, it is divided into:
High-purity aluminum plate (rolled from high-purity aluminum with a content of more than 99.9%)
Pure aluminum plate (the composition is basically rolled from pure aluminum)
Alloy aluminum plate (composed of aluminum and auxiliary alloys, usually aluminum-copper, aluminum-manganese, aluminum-silicon, aluminum-magnesium, dll.)
Composite aluminum plate or brazing plate (special-purpose aluminum plate material obtained by compounding multiple materials)
Aluminum-clad aluminum plate (aluminum plate is clad with thin aluminum plate for special purpose)
In the aluminum alloy, the grade is representative. The following is an example based on the grade of 7075T651 aluminum plate. The first 7 represents the group of aluminum and aluminum alloys – aluminum-zinc-magnesium alloys. The aluminum and aluminum alloy groups are divided into nine categories. Among them, 1, 3, 5, 6, and 7 series of aluminum and aluminum alloys are the main ones, and among them, 1 series and 3 series aluminum plates are the most commonly used, and other series are less likely to be used in actual use.
The first category: 1 seri: industrial pure aluminum
The second category: 2 seri: aluminum copper alloy
The third category: 3 seri: aluminum manganese alloy
The fourth category: 4 seri: aluminum-silicon alloy
The fifth category: 5 seri: aluminum-magnesium alloy
The sixth category: 6 seri: aluminum-magnesium-silicon alloy
The seventh category: 7 seri: Al-Zn-Mg-Cu alloy
The eighth category: 8 seri: other alloys
Ninth category: 9 seri: spare alloy
Technical quality requirements of aluminum plate:
1. The most basic point is that the surface of the plate must be clean, and no cracks or other oxidized impurities are allowed.
2. Due to the imperfection of the process, the surface of the plate is allowed to have defects such as dents, scratches or roll marks, but its depth must not exceed the allowable negative deviation of the plate. If the deviation exceeds the value, it will be remade.
3. Process Aluminum-clad thick plates are allowed to have shedding parts of the cladding layer and bubbles in the cladding layer.
4. Under normal circumstances, the surface of the plate is allowed to repair and remove defects within the range of thickness difference.
5. Some other requirements are mainly drawn up with the demanders and suppliers themselves, and then the process is changed.
The above is about the quality requirements on the surface of the aluminum plate. Although there may be certain errors due to some reasons, it must not exceed the controllable deviation value.